Sky Remote 4 Digit set up
Stage 1
Step No |
Keys to press |
Red light |
Notes |
|---|---|---|---|
1 |
TV |
0 |
' |
2 |
red + Select (for at least 2 seconds ) |
2 |
' |
3 |
TV |
0 |
' |
4 |
4 digit code |
2 |
If the red light blinks only once check the code and go back to step 1 |
5 |
stand by |
0 |
If you have found the correct code the TV should switch off, if it doesn't switch off press TV and standby and repeat untill it does then go to step 6. If while doing this the red light blinks 3 times it has checked all the possible settings for the code used. Check the code and go to step 1 |
6 |
select |
2 |
Stage 2
| Step No | Keys to press | Red light on remote blinks |
Notes |
|---|---|---|---|
1 |
TV Guide |
0 |
If you see the TV guide the set up is complete, if not continue |
2 |
TV |
0 |
' |
3 |
Green and select (for at least 2 seconds ) |
2 |
' |
4 |
The channel nujmber for watching satellite tv |
0 |
' |
5 |
select |
2 |
Set up is complete |
Alternative instructions
- Turn on your TV.
- Press tv on your Sky remote control.
- Hold down select and the red button together for about two seconds, until the red light on the Sky remote control blinks twice.
- Key in the three digits of the first 'Direct Set' code for the manufacturer of your TV; the red light on the Sky remote control will blink twice.
- Press tv and try the handset, using all the function buttons like power, volume and channel etc. If it works all the TV functions.
- If the Direct set code did not work then start again from step 1 with the next three digit code in the list for the manufacturer of your TV.
- Press tv guide. If you see the TV Guide screen, the remote control setup process is complete. If you did not see the TV Guide, you must now set the TV Guide function as follows:
- Press tv on your Sky remote control.
- Hold down select and the green button together for about two seconds, until the red light on the Sky remote control blinks twice.
- Key in the number of the channel on your TV that you use for watching satellite TV (For scart switching, this may be one of the other buttons on your remote e.g. help, i or a colour button).
- Press select on your Sky remote control. The red light blinks twice. The remote control setup process is complete.